First, you need to adjust the position of the lifting arm to ensure that the pads on the arm are perfectly aligned with the vehicle's intended lifting points. These lifting points are specifically designed to support the car, so choosing the right position is crucial.
Next, press the Lift button and carefully observe whether the vehicle remains horizontal at the moment of lifting. This step is very important because it ensures that the vehicle remains stable throughout the lifting process.
After that, lift the vehicle about 5 to 10 cm off the ground and pause the operation. At this time, you need to check whether the lifting process is smooth and whether there are any deviations in the various support points. If you find any problems, you should immediately put the vehicle back in place for adjustment.
Once you have confirmed that the lifting process is correct, you can continue to lift the vehicle to the required height for repair and stop it. After this, always pull down the locking device and check again whether the vehicle is stable. Only after confirming that the vehicle is stable, you can proceed to the next repair operation.
After completing the repair work, you need to put the vehicle back on the ground. At this point, first make sure the site has been cleared, then unlock the locking device and lower the vehicle smoothly. Finally, open the lifting arm and drive the vehicle out of the stacker parking lift, and the entire lifting process is over.
There are several points that need special attention during the process of lifting the vehicle. First, always make sure that the car is properly supported and use a safety lock to prevent it from falling. Second, it is best to consult the vehicle maintenance manual before lifting to understand the correct support point location. The wrong support point may not only cause damage to the vehicle, but also pose a safety hazard.
In addition, when using the stacker parking lift, certain safety operating procedures must be followed. For example, nearby obstacles should be cleared before operation, and the operating handle should be checked for normal operation. During the lifting process, personnel should stay away from the vehicle and insert the safety lock pin after reaching the required height to ensure safety. At the same time, avoid tedious or heavy physical labor on the stacker parking lift, and minimize frequent lifting operations.
Finally, after the operation, the debris around the stacker parking lift should be cleaned up to keep the site clean. In addition, the oil level and lubrication condition of the stacker parking lift should be checked regularly to ensure that it is in good working condition.
